Bale spear

Round bales can weigh a ton or more, and are well-suited for modern large scale farming operations such as a dairy with 200 or more cows. However, due to the ability for a round bale to roll away on a slope, they require special transport and moving equipment.

The most important tool for round bale handling is the bale spear or spike, which is usually mounted on the back of a tractor or the front of a skid-steer. It is inserted into the approximate center of the round bale, then lifted up and the bale is hauled away. Once at the destination, the round bale is set down, and the spear pulled out. Careful placement of the spear in the center is needed or the round bale can spin around and touch the ground while in transport, causing a loss of control.

Alternatively, a grapple fork may be used to lift and transport round bales. The grapple fork is a hydraulically driven implement attached to the end of a tractor's bucket loader. When the hydraulic cylinder is extended the fork clamps downwards towards the bucket, much like a closing hand. To move a round bale the tractor approaches the bale from the side and places the bucket underneath the bale. The fork is then clamped down across the top of the bale, and the bucket lifted with the bale in tow.

It is difficult to flip a round bale so that the flat surface is facing down and later flip it back up on edge, so transporting many round bales a long distance is a challenge. Flat-bed transport is difficult since the bales could roll off the truck bed going around curves and up hills. To prevent this, the flat-bed trailer is equipped with rounded guard-rails at either end, which prevent bales from rolling either forward or backward. Another solution for this is the saddle wagon, which has closely-spaced rounded saddles or support posts for round bales to sit in. The tall sides of each saddle, or the bale settling down in between posts, prevent the bales from rolling around while on the wagon.

Round bales can be directly used for feeding animals by placing it in a feeding area, tipping it over, removing the bale wrap, and placing a protective ring around the outside so that animals don't walk on hay that has been peeled off the outer perimeter of the bale. The baler's forming and compaction process can assist in unrolling a round bale, as it is often possible to unroll a round bale in a continuous flat strip.

Permission is granted to copy, distribute and/or modify this document
under the terms of the GNU Free Documentation License, Version 1.2
or any later version published by the Free Software Foundation